Yard Stik Park Flyer ARF

This is the Radio Controlled, Electric Powered, Almost Ready-to-Fly Great Planes ElectriFly Yardstik Park Flyer Airplane Kit.
Park Pilot Program Legal Aircraft

For Beginner to Intermediate Modeler/Fliers.
Performing well at speeds no faster than a brisk walk, the Yardstik is perfect for small areas indoors or outdoors.

FEATURES:
Construction: Built up wood wing and tail section
Wings: Reinforced with carbon fiber leading and trailing edges, pre-covered in iron-on transparent film with Maltese cross decals

**NOTE: These wings are purposely built with 2 of washout (twist)**
******in each panel for stability and proper flying performance*****

Boom: Carbon fiber (33" (838mm) long and 1/4" (6mm) in diameter
Motor: 280 size (GPMG0300) with 3.5:1 (GPMG0204) gearbox and 10x4.5" nylon propeller
Radio compartment: Nylon center pod holds battery and on-board radio gear
Landing Gear: Prebent wire (.063 (1.62mm) diameter wire
Wheels: Molded nylon 3" in diameter
Motor Mount: Included
Warranty: 90 days

INCLUDES:
One Great Planes ElectriFly Yardstik Park Flyer airplane with, motor gearbox, 10x4.5 nylon propeller, landing gear, two 3" dia. wheels, decal sheet and photo illustrated instructions

REQUIRES:
5A or great ESC
7-cell 650mAh battery
Charger
Radio: 3-channel with mini receiver
(Can use GPML0044 or GPML0045 for Rx)
Servos: Two, micro, mini, or two nano size servos (can use FUTM0025)*
Misc. Items: building and field equipment

SPECS:
Wingspan: 41" (1040mm)
Wing Area: 496 sq in (32 sq dm)
Weight: 11-12oz (310-340g)
Wing Loading: 3oz/sq ft (9g/sq dm)
Length: 38.5" (980 mm)
Airfoil: flat bottom, High Wing
Center of Gravity: 3-7/8" (98mm) Back from the wing's leading edge at the fuselage sides.
Control Throws- Low Rate High Rate
Elevator: Up & Down " (19mm) " (19mm)
Rudder: Right & Left 1" (25.4mm) 1" (25.4mm)

COMMENTS:
The threaded prop adapter included with the Yardstik was designed for use with the optional APC propellers mentioned in the instruction manual. The kit-supplied Great Planes prop (black) has a slightly thicker hub than the APC props. When installing the Great Planes prop, please omit the aluminum prop washer-securing the prop on the threaded shaft with the prop nut only. This method is perfectly acceptable. If mounting an APC prop, please use the included aluminum prop washer between the prop and the prop nut.

Only one receiver is required depending on the channel of the radio selected (Low band Ch 11-35, High band Ch 36-60). Please note the Accessory Completion Guide lists both Low and High band receivers. Channel selection is left to the modeler's preference.

For replacement prop, use APCQ5015.
Uses a 3mm prop adapter GPMQ4600

NOTE:
*The S3108 servo will not work because the mounting holes will not line up correctly.